How can local SBC hardware be projected in Simatic-Manager?

FAQ #100053

 

Local SBC hardware (I/O modules) is configured with the I/O Builder. Then the I/O Builder is used to generate an STL source, which is imported into the S7 project and compiled. The hardware configuration is therefore defined in a data block (DB1, DB 511 or DB 1023). When reconstructing or modifying the HW configuration, a PCD restart (Stop/Start) is always required. The I/O Builder can be downloaded free-of-charge from Internet address: www.sbc-support.ch/overview/xx7Configuration.htm

 

Categories

xx7 Series / Hardware configuration

Last update: 24.05.2015 06:53

First release: 08.06.2004 15:45

Views: 11190

The requested software / document is no longer marketed by Saia-Burgess Controls AG and without technical support. It is an older software version which can be operated only on certain now no longer commercially available products.

Download